Height (bottom to top of tap) 97cm.
Height (bottom to basin) 81cm.

A small 15-20cm gap is recommended from the floor to the base when mounting so that the basin is at standard height for hand washing 90cm - 100cm high, and for cleaning accessibility under the fixture.

Width (left to right) 45cm.
Depth (front to back) 30cm.
Empty Weight 19kgs.

Bowl Capacity/Dimensions
Height (top to bottom) 14cm.
Width (left to right) 41cm.
Depth (front to back) 20cm.
Capacity 11.5 Litres

10 amp, 220/240 VAC power, 2400W (normal household powerpoint).

The Commercial Sink draws next to no power when it is idle, when it is activated, the in-built instantaneous hot water heater and pump operate (for approx 10 seconds) and draw a full 10 amps.

Comes fitted with a standard 2 metre power lead and moulded 10 amp plug.

The Commercial Sink has a dual water reservoir which hygienically separates and stores both fresh and waste water.

The 10 litre capacity will provide up to 50 x ten second hot water hand washes (40/45 degrees) per filling. More than enough for most work areas, spare containers are available for rapid changeover if needed though.

There is a cold water, continuous flow button inside the unit.

The Commercial Sink is designed to give a timed, temperature regulated rinse so as to reduce common errors in performing proper hand hygiene. For this reason the temperature is factory set to 40/45 degrees celsius and cannot be adjusted. Why 40/45 degrees? Because warm water is more likely to encourage hand washing than cold water, most regulations require it, and modern soaps work better with it. The unit has an automatic safety cut off so that water cannot become too hot.

Transplumb Water Technologies reserves the right to make changes in specification without prior notification.